Fanuc Alarm 38: INTERFERENCE IN CIRCULAR BLOCK Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description Overcutting will occur in tool radius/tool nose radius/cutter compensation because the arc start point or end point coincides with the arc center. Modify the program. Help…
Fanuc Alarm 37: CAN NOT CHANGE PLANE IN CRC Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description G40 is commanded on the plane other than offset plane in cutter compensation B (M Series). The plane selected by using G17, G18 or…
Fanuc Alarm 35: CAN NOT COMMANDED G39 / G31 Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description G39 is commanded in cutter compensation B cancel mode or on the plane other than offset plane (M Series). Skip cutting (G31) was specified…
Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description M Series;The start up or cancel was going to be performed in the G02 or G03 mode in cutter compensation C. Modify the…
Fanuc Alarm 33: NO SOLUTION AT CRC Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description M Series: A point of intersection cannot be determined for cutter compensation C. Modify the program. T Series: A point of intersection cannot be determined for…
Fanuc Alarm 32: ILLEGAL OFFSET VALUE IN G10 Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description In setting an offset amount by G10 or in writing an offset amount by system variables, the offset amount was excessive. Help the CNC Community:…
Fanuc Alarm 31: ILLEGAL P COMMAND IN G10 Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description In setting an offset amount by G10, the offset number following address P was excessive or it was not specified. Modify the program. Help the…
Fanuc Alarm 30: ILLEGAL OFFSET NUMBER Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description M Series;The offset values specified by D/H code for tool length offset, cutter compensation or 3–dimensional cutter compensation is too large. Otherwise, the number specified by P…
Fanuc Alarm 29: ILLEGAL OFFSET VALUE Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description M Series;The offset values specified by H code is too large. Modify the program. Help the CNC Community: How Did You Fix It? If you have encountered…
Fanuc Alarm 36: CAN NOT COMMANDED G31 Fanus Control Model: 16/18/21, 16i/18i/21i Alarm Description Skip cutting (G31) was specified in cutter compensation mode. Modify the program. Help the CNC Community: How Did You Fix It? If you have encountered this…