Fanuc Alarm 5124 CAN NOT COMMAND SPIRAL
Fanus Control Model: 16/18/21, 16i/18i/21i
Alarm Description
A spiral interpolation or conical interpolation was specified in any of the following modes;1) Scaling;2) Programmable mirror image;3) Polar coordinate interpolation In cutter compensation C mode, the center is set as the start point or end point.
Help the CNC Community: How Did You Fix It?
If you have encountered this Fanuc Alarm 5124 CAN NOT COMMAND SPIRAL error code before or know a proven troubleshooting step to resolve it, please share your solution in the comments below